Parameterization Of Relevant Properties - Siemens SINUMERIK 840D sl Configuration Manual

Safety configuration

10.4 Parameterization of relevant properties

10.4 Parameterization of relevant properties
The Safety Integrated modes of the NCU control the safety behavior of the NCU together with
the integrated subcomponents, such as the PLC, SINAMICS Integrated and possibly
connected NX modules. Depending on the used mode and communications standard
(PROFINET or PROFIBUS), you must configure further relevant properties and F-parameters
for various modules. Sample configuring sequences can be found in Sections Configuring
Safety Integrated (SPL) (Page 187) and Configuring Safety Integrated plus (F-PLC)
(Page 201).
You can, however, also parameterize the appropriate properties in a different order.
Overview
The following table shows in which device properties and in which section you find a specific
configuration-relevant setting:
Note that not all parameters are relevant in both Safety Integrated modes. In addition, some
parameters are displayed only in a specific Safety Integrated mode for the SINAMICS
Integrated and NX components and the associated telegrams.
Table 10-1
Setting
Safety Integrated mode (op‐
erating mode)
Basis for PROFIsafe ad‐
dresses
F-source address
(F_Source_Add)
F-destination address
(F_Dest_Add)
DIL switching setting
178
Configuration-relevant properties
Can be found at
NCU > Safety Integrated
PLC > Fail-safe > F-parameters
PLC > Fail-safe > F-source ad‐
dresses
(only for Safety Integrated mode
(SPL))
(for a GSD module, also under
"Module > PROFIsafe")
Module/submodule > F-parame‐
ters
Module/submodule > F-parame‐
ters
Further information
● This chapter, "NCU properties"
section.
● Changing the Safety
Integrated mode (Page 175)
● Safety Integrated mode (SPL)
● Safety Integrated plus mode (F-
PLC)
● Information system, keyword
"Basis for PROFIsafe
addresses".
● Configuration of the
PROFIsafe addresses
(peripherals)
● Configuration of the
PROFIsafe addresses (drives)
● Information system, keyword
"Special considerations when
configuring the F-system"
● Information system, keyword
"Special considerations when
configuring the F-system"
● Configuring Safety Integrated
plus (F-PLC) (handling
overview)
● Configuring Safety Integrated
(SPL) (handling overview)
SINUMERIK STEP 7 Toolbox V15.1
Configuration Manual, 12/2018, A5E46279635B AA