Siemens SINUMERIK 840D sl Configuration Manual page 179

Setting
Default F-monitoring time for
F-peripherals of this interface
F-monitoring time
I/O address
Size of the PLC process im‐
age
Name of an I/O system node Device / header module > General ● Information system, keyword
IP address of an I/O system
node
NCU properties
The Safety Integrated mode of the NCU affects not only the configuration of the integrated PLC,
but rather also that of the integrated drives.
SINAMICS Integrated and NX modules always use automatically the same Safety Integrated
mode as the associated NCU.
Therefore, set this mode in the NCU properties and not in the PLC properties:
SINUMERIK STEP 7 Toolbox V15.1
Configuration Manual, 12/2018, A5E46279635B AA
10.4 Parameterization of relevant properties
Can be found at
Interface > F-parameters
Module/submodule > F-parame‐
ters
Module/submodule > I/O address‐
es
PLC > Cycle
Device / header module > PROFI‐
NET interface > Ethernet address‐
es
Safety configuration
Further information
● Information system, keyword
"Monitoring and response
times"
● Information system, keyword
"Configuring the F-peripherals"
● Information system, keyword
"Monitoring and response
times"
● Information system, keyword
"Addressing modules (S7-300,
S7-400)"
● Information system, keyword
"Settings for the cycle behavior
(S7-300, S7-400)"
● Information system, keyword
"S7-300 memory areas"
"Assign device name and IP
address"
● Information system, keyword
"Assign device name and IP
address"
179