Indicator Lamp In The Charging Station - Husqvarna AUTOMOWER 305 Operator's Manual

Message Cause
Guide calibration
The product has succeeded to calibrate
done
the guide wire.
Connection
New loop signal successfully changed.
changed
6.4 Indicator lamp in the charging
station
The indicator lamp in the charging station must show a solid or flashing green light for a correct
installation. If not, follow the instructions in the troubleshooting guide below.
You can also find information on www.husqvarna.com. Speak to your Husqvarna customer service for
more information.
Light Cause
Green solid light
Good signals
Green flashing
The signals are good and
light
activated.
Blue flashing light
The boundary loop is not connected to
the charging station.
Break in the boundary loop.
Red flashing light
Interruption in the charging station's an-
tenna.
Red solid light
Fault in the circuit board or incorrect
power supply in the charging station.
The fault should be rectified by an au-
thorized service technician.
48 - Troubleshooting
Action
No action.
No action.
Action
No action required
ECO mode is
No action required. For more informa-
ECO mode . Refer to ECO mode
tion on
on page 31 .
Check that the boundary wire connec-
tors are fitted properly to the charging
station. Refer to
wire on page 21 .
Find out where the break is. Replace
the damaged section of the loop with a
new loop wire and splice using an origi-
nal coupler.
Contact Husqvarna customer service.
Contact Husqvarna customer service.
To install the boundary
1462 - 001 - 24.02.2020