To Charge The Battery; Adjust The Cutting Height - Husqvarna AUTOMOWER 305 Operator's Manual

Example: A specified work area of 500 m
Operation, A + C = max. hours
Charging/Standby, B + D = min. hours 14

4.9 To charge the battery

WARNING: Only charge the product
using a charging station which is
intended for it. Incorrect use may result
in electric shock, overheating or
leakage of corrosive liquid from the
battery.
In the event of leakage of electrolyte
flush with water and seek medical help
if it comes in contact with the eyes etc.
When the product is new or has been stored for a
long period, the battery can be empty and needs
to be charged before starting. In the
mode, the product automatically alternates
between mowing and charging.
1. Push the ON/OFF for 3 seconds button to
start the product.
2. Place the product in the charging station.
Slide the product in as far as possible to
ensure proper contact between the product
and the charging station. Refer to contact
and charging plates in
page 4
3. The display shows a message that charging
is in progress.
38 - Operation
2
10
Main area
Product overview on

4.10 Adjust the cutting height

CAUTION: During the first weeks after
a new installation, the cutting height
must be set to MAX to avoid damaging
the loop wire. After this, the cutting
height can be lowered step by step
every week until the desired cutting
height has been reached.
The cutting height can be varied from MIN (2 cm /
0.8 in.) to MAX (5 cm / 2 in.).
4.10.1 To adjust the cutting height
1. Push the STOP button to stop the product.
2. Open the hatch.
3. Turn the knob to the required position.
• Turn clockwise to increase the cutting
height.
• Turn counter-clockwise to decrease the
cutting height.
4. Close the hatch.
1462 - 001 - 24.02.2020