Husqvarna AUTOMOWER 305 Operator's Manual page 45

Message Cause
Lifted
The lift sensor has been activated as
the product has been lifted.
Wheel drive prob-
Grass or other object is wrapped
lem, right/left
around the drive wheel.
Electronic problem Temporary electronic or firmware rela-
ted issue in the product.
Loop sensor prob-
lem, front/rear
Tilt sensor prob-
lem
Temporary prob-
lem
Invalid sub-device
combination
Temporary battery
problem
Safety function
faulty
Charging system
Incorrect type of battery.
problem
Battery problem Temporary battery or firmware related
issue in the product.
Incorrect type of battery.
Battery tempera-
The temperature in the battery is too
ture outside limits
high or too low to start operation.
Charging current Wrong or faulty power supply unit.
too high
Connectivity prob-
Potential problem on the connectivity
lem
circuit board in the product.
Connectivity set-
The connectivity settings was restored
tings restored
due to a fault.
1462 - 001 - 24.02.2020
Action
Check that the product body can move
freely around its chassis. Remove or
create an island around objects that
can cause the chassis to be lifted. If the
problem stays speak to your authorized
service technician.
Clean the wheels and around the
wheels.
Restart the product. If the problem
stays speak to your authorized service
technician.
Use original batteries recommended by
the manufacturer.
Restart the product. If the problem
stays speak to your authorized service
technician.
Use original batteries recommended by
the manufacturer.
No action. The product will start to op-
erate when the temperature is in limits.
Restart the product. If the problem
stays speak to your authorized service
technician.
Restart the product. If the problem
stays speak to your authorized service
technician.
Check and change the settings if nee-
ded.
Troubleshooting - 45