Husqvarna AUTOMOWER 305 Operator's Manual page 26

3. Use the arrow buttons and the OK button to
move through the menu structure
Advanced > New loop signal .
4. Await confirmation that the loop signal has
been generated. This normally takes about
10 seconds.
To change the PIN-code
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Security > Advanced > Change PIN-code .
3. Enter the new PIN code.
4. Push the OK button.
5. Enter the new PIN code.
6. Push the OK button.
7. Make a note of the new PIN code. Refer to
Introduction on page 3 .
To change the duration of the alarm
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Advanced > Duration > Duration of alarm .
3. Use the arrow buttons to select a time
interval of 1 to 20 minutes.
4. Push the BACK button.
To change the duration of the time lock
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Advanced > Duration > Duration of time
lock .
3. Use the number buttons to select a time
interval of 1–90 days.
4. Push the BACK button.
3.10.3.6 Messages
In this menu the previous fault and information
messages can be found. For some of the
messages, there are tips and advice to help to
Troubleshooting on page
rectify the fault. Refer to
42 .
26 - Installation
If the product is disrupted in any way, for
Security > example it is trapped or the battery is low, a
message is saved relating to the disruption and
the time it happened.
If the same message is repeated several times,
this may indicate that an adjustment to the
installation or the product is required. Refer to
Installation on page 15 .
To read the messages
1. Do steps 1–3 in
on page 24 .
Settings >
2. Use the arrow buttons and the OK button to
move through the menu structure
> Fault messages and Messages > Info
messages .
3. Read the messages and read the
Troubleshooting to get information and
recommendations to correct the faults.
3.10.4 Weather timer
automatically adjust the cutting time to the growth
Security >
of the grass. The product is not permitted to
operate more than the schedule settings.
Note: When using , it is recommended to make
as much operating time as possible available for .
Do not restrict the schedule more than
necessary.
The first operation of the day is set by the
schedule settings. The product always complete
Security >
1 mowing cycle, and then selects if the product
will continue to operate or not.
Note: is reset if the product does not operate for
more than 50 hours, or if a
settings is done. is not changed if a Reset of
schedule settings is done.
3.10.4.1 To set the Weather timer
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
timer > Use Weather timer .
To get access to the menu
Messages
Reset of all user
To get access to the menu
Weather
1462 - 001 - 24.02.2020