Husqvarna AUTOMOWER 305 Operator's Manual page 28

Note: The sum of Area 1-3 must be 100% or
less. If the sum is less than 100%, the
product sometimes straddles the guide wire
and starts to mow at the charging station.
9. Push the BACK button.
3.10.5.2 To set the System Passage Mowing
function
Note: To prevent that the grass in the narrow
passage is worn, Husqvarna recommends to set
Systematic Passage
a low percentage for the
Mowing .
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Lawn Coverage > Area 1-3 .
3. Use the arrow buttons to select the area.
4. Push the OK button.
5. Measure the distance from the charging
station to the beginning of the narrow
passage. Measure along the guide wire.
To measure the distance from the
Refer to
charging station on page 28 .
Note: Make sure that the distance to the
Systematic Passage Mowing is set inside
the narrow passage.
6. Push the arrow buttons to select the
distance.
7. Push the OK button.
8. Use the arrow buttons to select the % of the
cutting time that the product must start the
narrow passage cutting.
9. Use the arrow buttons and the OK button to
More > Systematic Passage Mowing .
select
10. Push the OK button to enable
Passage Mowing .
11. Push the BACK button.
3.10.5.3 To do a test of the Lawn Coverage
function
1. Put the product in the charging station.
To get access to the menu on
2. Do step 1-3 in
page 24 .
28 - Installation
3. Use the arrow buttons and the OK button to
move through the menu structure
Lawn Coverage > Area > More > Test .
4. Push the OK button.
5. Push the START button.
6. Close the hatch.
7. Make sure the product can find the area.
3.10.5.4 To measure the distance from the
charging station
1. Put the product in the charging station.
2. Do steps 1–3 in
on page 24 .
3. Use the arrow buttons and the OK button to
move through the menu structure
Lawn Coverage > Area > How far?
4. Use the arrow buttons to set m as a
Settings >
distance.
5. Push the OK button.
6. Use the arrow buttons and the OK button to
move through the menu structure
Lawn Coverage > Area > More > Test .
7. Push the OK button.
8. Push the STOP button when the product is
at the distance you select to measure. The
distance shows in the display.
3.10.5.5 To disable or enable the Lawn Coverage
function
Disable or enable the
each area.
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Lawn Coverage > Area > Disable .
3. Push the OK button.
4. Push the BACK button.
Systematic
3.10.5.6 To reset the Lawn Coverage settings
You can reset the
each area and use the factory setting.
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Lawn Coverage > Area > More > Reset .
3. Push the OK button.
Settings >
To get access to the menu
Settings >
Settings >
Lawn Coverage function for
To get access to the menu
Settings >
Lawn Coverage settings for
To get access to the menu
Settings >
1462 - 001 - 24.02.2020