Husqvarna AUTOMOWER 305 Operator's Manual page 19

with raised roots, must be isolated or removed.
The product can run onto this kind of obstacle
causing the blades to be damaged. Use the
boundary wire to isolate areas inside the work
area by creating islands. When the boundary
wires to and from the island are put close
together, the product can run over the wire.
Note: To achieve careful and silent operation, it is
recommended to isolate all fixed objects in the
work area.
• Put the boundary wire to and around the
obstacle to make an island.
• Put the 2 sections of boundary wire that run
to and from the obstacle close together
without crossing.
• Put the 2 sections of boundary wire in the
same stake.
0 cm / 0"
3.4.3.4 To make a secondary area
Make a secondary area (B) if the work area has 2
areas that are not connected with a passage. The
work area with the charging station is the main
area (A).
Note: The product must be manually moved
between the main area and the secondary area.
1462 - 001 - 24.02.2020
B
A
• Put the boundary wire around the secondary
area (B) to make an island. Refer to
make an island on page 18 .
Note: The boundary wire must be put as 1
loop around all of the work area (A + B).
Note: When the product cuts grass in the
secondary area, the
must be selected. Refer to
Start on page 35 .
3.4.4 To examine where to put the guide
wire
• Put the guide wire in a line at a minimum of
2 m / 6.5 ft. in front of the charging station.
• Make as much free area as possible to the
left of the guide wire when facing the
charging station. Refer to
page 30 .
• Put the guide wire minimum 30 cm / 12 in.
from the boundary wire.
• Do not make sharp bends when you install
the guide wire.
135º
135º
• If the work area has a slope, put the guide
wire diagonally across the slope.
To
Secondary area mode
Operating mode
Corridor width on
90º
Installation - 19