Husqvarna AUTOMOWER 305 Operator's Manual page 44

Message Cause
Alarm! Mower
The alarm is activated because the
switched off
product had been switched off.
Alarm! Mower The alarm is activated because the
stopped
product has been stopped.
Alarm! Mower lif-
The alarm is activated because the
ted
product has been lifted.
Alarm! Mower til-
The alarm is activated because the
ted
product has been tilted.
Alarm! Mower was
The alarm is activated because the
moved product has been lifted.
Charging station
The contact between the charging
blocked
plates on the product on the and con-
tact plates on the charging station may
be poor and the product has made a
number of attempts to charge.
An object is in the way of the product
that prevents it to enter the charging
station.
The charging station is tilted or bent.
The guide wire is not installed correctly. Check if the guide wire is installed ac-
Stuck in charging
There is an object in the way of the
station
product preventing it from leaving the
charging station.
Upside down
The product is leaning too much or has
turned over.
Needs manual
The product is set to the
charging area operating mode.
Next start hh:mm
The schedule setting prevents the
product from operating.
The rest period is in progress. The
product has an inbuilt standby period
according to the Standby time table.
The clock or date in the product is not
correct.
Today's mowing
The product has an inbuilt standby peri-
completed
od according to the Standby time table.
44 - Troubleshooting
Action
Adjust the security level in the
menu. Refer to
on page 25 .
Put the product in the charging station
and check that the charging plates and
contact plates make good contact.
Remove the object.
Put the baseplate on level ground.
cording to the instructions. Refer to
install the guide wire on page 22 .
Remove the object.
Turn the product the right way up.
Secondary
Put the product in the charging station.
Change the schedule settings. Refer to
Schedule on page 24 .
This behavior is normal and no action
is required.
Set the time. Refer to
date on page 32 .
This behavior is normal and no action
is required. Refer to
Standby on page 37 .
Security
To set the security level
To
To set the time &
Schedule and
1462 - 001 - 24.02.2020