Download  Print this page

To Do The Product Settings - Husqvarna AUTOMOWER 305 Operator's Manual

Hide thumbs

Advertisement

Note: If the battery is too low, the product
needs to charge the batteries fully before the
calibration starts. Refer to
page 24 .
3.9.3 Calibration
The calibration process is automatic. After the
basic settings are done, the product moves away
from the charging station and stops, while it
calibrates some of the product settings. When the
calibration is complete, the product starts to mow.

3.10 To do the product settings

All commands and settings for the product are
done via the control panel. The control panel
consists of a display and a keypad, and all
functions are accessed through the menus. The
functions have factory settings to suit most work
areas, but the settings can be adapted to the
unique situation for each work area.
3.10.1 Menu structure
The main menu contains:
Schedule
Security
Messages
Weather timer
Installation
Settings
Accessories
Menu structure overview - 1 on page 7
Refer to
Menu structure overview - 2 on page 8 .
and
3.10.2 To get access to the menu
1.
Push the STOP button.
2.
Use the number buttons and the OK button
to enter the PIN code.
3.
Push the MENU button.
3.10.3 Schedule
Note: The lawn should not be cut too often to
obtain the best result. If the product is allowed to
operate too much, the lawn may appear
24 - Installation
flattened. The product is also subjected to
unnecessary wear.
Calibration on
3.10.3.1 To set the schedule
1.
2.
3.
4.
5.
6.
7.
8.
3.10.3.2 To calculate the suitable operating hours
If the work area is less than maximum product
capacity, the schedule should be set to minimize
wear on the lawn and the product.
1.
2.
3.
Note: The daily operation capacity is approximate
and depends on the inbuilt standby period. Refer
Schedule and Standby on page 37 .
to
To get access to the menu
Do steps 1–3 in
on page 24 .
Use the arrow buttons and the OK button to
move through the menu structure
> Overview .
Use the arrow buttons and the OK button to
select the day.
Use the right arrow button to select the
period.
Push the OK button.
Calculate the suitable operating hours. Refer
To calculate the suitable operating hours
to
on page 24 .
Enter the time with the number buttons. The
product can cut the grass 1 or 2 periods
each day.
If the product must not cut grass on a
specified day, unselect the box adjacent to
the 2 time periods.
Calculate the dimension of your lawn in m
2
ft
.
2
2
Divide the m
/ ft
of the lawn with the
approximate daily operation capacity. Refer
to table below.
The result is equal to the number of hours
that the product must mow each day. The
number of hours includes both mowing,
searching and charging time.
1462 - 001 - 24.02.2020
Schedule
2
/

Advertisement

loading