Husqvarna AUTOMOWER 305 Operator's Manual page 27

3. Push the OK button to select the
timer .
4. Push the BACK button.
3.10.4.2 To set the Weather timer frequency
Set how frequently the product cuts the grass
Weather timer is in use. There are 3
when the
Low, Mid and High . The higher
frequency levels:
the frequency, the more sensitive the product is
to the grass growth. That is, if the grass growth is
high then the product is allowed to work longer.
Note: If the mowing results are not optimal when
Weather timer , the schedule settings may
using
need adjusting. Do not restrict the schedule more
than necessary. Also, check that the blade disc is
clean and that the blades are in good condition.
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
timer > Cutting time .
3. Use the arrow buttons to select
High frequency.
4. Push the BACK button.
3.10.5 Lawn Coverage and Systematic
Passage Mowing
If the work area includes remote parts that are
connected with narrow passages, the
Coverage and Systematic Passage Mowing
function are useful to be able to maintain a well-
cut lawn in all parts of the yard. The
Coverage function is used to guide the product to
remote parts of the work area. The
Passage Mowing function is used for narrow
passage mowing. A guide wire must be installed
to use these functions. You can set a maximum
of 3 remote areas.
Lawn Coverage function the product first
With the
follows and then leaves the guide wire after a
certain distance and starts to mow the lawn.
Systematic Passage Mowing function is
The
suitable to mow narrow passages of 60 cm - 1.5
m / 23 in. - 4.9 ft. width. The product moves in a
pattern to cover the passage width. The product
Systematic Passage Mowing at the set
starts the
distance from the charging station. When the
product reaches the end of the narrow passage,
1462 - 001 - 24.02.2020
Weather
the product continues and cuts the lawn as
normal.
Area A, approximately 50%
Area B, approximately 30%
Area C, approximately 20%
Weather
3.10.5.1 To set the Lawn Coverage function
Low, Mid or
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Lawn Coverage > Area 1-3 .
3. Use the arrow button to select the area.
4. Push the OK button.
Lawn
5. Measure the distance from the charging
station to the start of the area. Measure
Lawn
along the guide wire. Refer to
the distance from the charging station on
Systematic page 28 .
6. Push the arrow buttons to select the
distance, measured in m.
7. Push the OK button.
8. Use the arrow buttons to select the
percentage of the cutting time the product
must cut the area. The percentage is equal
to the percentage of the area in relation to
the complete work area.
a)
b)
c)
A
To get access to the menu
Measure the area.
Divide the measured area with the total
work area.
Convert the result to percentage.
Installation - 27
C
B
Settings >
To measure