Husqvarna AUTOMOWER 305 Operator's Manual page 43

Message Cause
Empty battery
The product cannot find the charging
station.
The battery is spent.
The charging station's antenna is de-
fective.
The charging plates on the product or
contact plates on the charging station
are corroded.
Wrong PIN code
Wrong PIN code has been entered.
Five attempts are permitted, and the
keypad is then blocked for a period of
time.
No drive
The product has got caught in some-
thing and has been slipping.
The work area includes a steep slope.
The guide wire is not laid diagonally in
the slope.
Wheel motor over-
Grass or other object is wrapped
loaded, left/right
around the drive wheel.
Collision sensor
The product body can not move freely
problem, front/rear
around its chassis.
1462 - 001 - 24.02.2020
Action
Change the position of the guide wire.
To install the guide wire on
Refer to
page 22 .
Replace the battery. Refer to
on page 41 .
Check if the indicator lamp in the
charging station flashes red. Refer to
Indicator lamp in the charging station
on page 48 .
Clean the charging and contact plates
using a fine grade emery cloth. If the
problem stays speak to your authorized
service technician.
Enter the correct PIN code. Contact
Husqvarna customer service if you for-
get the PIN code.
Free the product and rectify the reason
for the lack of drive. If it is due to wet
grass, wait until the lawn has dried be-
fore using the product.
Steep slopes should be isolated. Refer
To put the boundary wire in a slope
to
on page 18 .
Make sure that the guide wire is instal-
led diagonally across the slope. Refer
To make a secondary area on page
to
19 .
Check the drive wheel and remove
grass or object.
Check that the product body can move
freely around its chassis. If the problem
stays speak to your authorized service
technician.
Troubleshooting - 43
Battery