To Bury The Boundary Wire Or The Guide Wire; To Extend The Boundary Wire Or The Guide Wire; After The Installation Of The Product - Husqvarna AUTOMOWER 305 Operator's Manual

CAUTION: Cutting the grass too low
right after installation can damage the
wire insulation. Damage to the
insulation may not cause disruptions
until several weeks or months later.
1. Put the boundary wire and the guide wire on
the ground.
2. Put the stakes at a maximum of 75 cm / 30
in. distance from each other.
3. Attach the stakes to the ground with a
hammer or a plastic mallet.
Note: The wire is overgrown with grass and not
visible after a few weeks.
3.7 To bury the boundary wire or the
guide wire
• Cut a groove in the ground with an edge
cutter or a straight shovel.
• Put the boundary wire or the guide wire 1-20
cm / 0.4-8 in. into the ground.
3.8 To extend the boundary wire or the
guide wire
Note: Extend the boundary wire or the guide wire
if it is too short for the work area. Use original
spare parts, for example couplers.
1. Disconnect the charging station from the
power outlet.
2. Cut the boundary wire or the guide wire with
a pair of wire cutters where it is necessary to
install the extension.
3. Add wire where it is necessary to install the
extension.
4. Put the boundary wire or the guide wire into
position.
5. Put the wire ends into a coupler.
Note: Make sure that you can see the ends
of the boundary wire or the guide wire
through the transparent area of the coupler.
6. Push the button on the coupler with an
adjustable pliers.
1462 - 001 - 24.02.2020
7. Put the boundary wire or the guide wire into
position with stakes.
8. Connect the charging station to the power
outlet.

3.9 After the installation of the product

3.9.1 To do a visual check of the charging
station
1. Make sure that the indicator LED lamp on
the charging station has a green light.
2. If the indicator LED lamp does not have a
green light, do a check of the installation.
Indicator lamp in the charging
Refer to
station on page 48 and To install the
charging station on page 20 .
3.9.2 To do the basic settings
Before the product starts to operate for the first
time, you must do the basic settings.
1. Put the product in the charging station.
2. Switch on the product.
3. Push the arrow buttons and the OK button.
Select language, country, date, time and set
a PIN code.
Note: It is not possible to use 0000 as PIN
code.
4. Push the Start button and close the hatch to
initiate a calibration process of the product.
Installation - 23