Advertisement
S
C
C
ERIAL
ABLE
ONNECTIONS
Full Height Tape Drive Configuration
Library
Figure 2
Serial cable routing—full height tape drives
Notes:
Do not switch the internal connectors–the bottom tape drive must be connected to the bottom serial
connector, the second tape drive (both HH and FH) must be connected to the second serial connector, and so
forth. The top two connectors are not used with an FH configuration.
R
"B" P
EVISION
OWER
Your library shipped with one of these power supplies installed at the factory:
Revision "A" power supply (no label affixed)
Revision "B" power supply (Rev "B" label affixed–see
!
When you add a third (or third and fourth) half height LTO-3 tape drive, you may need to
Important
upgrade your power supply. Contact Technical Support at
additional information.
If your power supply has this label affixed, you do NOT need a new power supply to support
the additional tape drives.
Figure 3
Rev "B" power supply label
4
16
OF
Drive 4
Drive 3
Drive 2
Drive 1
S
UPPLY
Half Height Tape Drive Configuration
Serial cable
Top serial
connector
Third serial
connector
Second serial
connector
Bottom serial
connector
Figure 3
below)
Library
www.tandbergdata.com
Power supply
Rev "
Drive 4
Drive 3
Drive 2
Drive 1
for
B
" label
Advertisement
