Figure 2-3 Connecting The Scsi Cable And Power Cable - Tandberg Data VXA-320 (VXA-3) Product Manual

Do not use a screw other than the type specified for attaching the grounding wire,
Caution
or you may damage the internal components. Screw length must not exceed
5mm.
4.
To avoid damaging the tape drive, make certain you connect pin 1 on the cable to
Caution
pin 1 on the tape drive. Pin 1 is on the right, top row of the connector pins (see
Figure
Figure 2-3 Connecting the SCSI cable and power cable (another device is the last
O 2006
CTOBER
Connect an M3 (0.25 in.) female spade connector from the host to the
tape drive's grounding tab.
or
×
Use an M3 0.5 mm
to the grounding hole.
Connect the SCSI cable.
a. Check the connector to ensure that no pins are bent or pushed in before
connecting it to the tape drive.
2-3).
b. Connect one of the enclosure's internal SCSI cables to the SCSI connector
on the back of the tape drive (see
guidelines in "SCSI Cable Requirements," beginning on page
Note: If desired, you can mount the tape drive (see
connect the SCSI cable, the terminator (if required), and the power
cable to the back. However, if the cables are difficult to access in the
enclosure, you should extend the cables out through the drive bay
and connect them before mounting the tape drive.
SCSI
connector
to additional
SCSI device
to SCSI
adapter card
device on the bus)
×
5 mm machine screw to connect a grounding wire
Figure 2-3). This cable must meet the
Pin 1
I T D
NSTALLING THE APE
41.
page 12) before you
Power
connector
from host computer
power supply
VXA-320 T D
APE RIVE
11
RIVE