Installation - Tandberg Data Magnum 448 Manual

The library is now ready to resume operation. The new tape drive defaults to the following SCSI IDs:
Library
Magnum 448
!
Important
C
ONFIRMING THE
You may want to perform a few load and unload operations and back up several megabytes of data to ensure
that the library and the newly installed tape drive (or tape drives) are communicating correctly.
Use LibTool to
Use LTOTool to
Download and install the tools from www.tandbergdata.com. The readme file that accompanies the program (or
the online help for the Windows version) provides instructions for using the tools.
For questions regarding software configuration, installation, or operation (including how to perform a backup
operation)—contact your software provider.
Copyright 2009 Tandberg Data Corporation: Tandberg Data, Exabyte, the Exabyte Logo, EZ17, M2, SmartClean, VXA, and VXAtape are registered trademarks; ExaBotics and MammothTape are
trademarks; SupportSuite is a service mark. Linear Tape-Open, LTO, the LTO Logo, Ultrium and the Ultrium Logo are trademarks of HP , IBM, and Quantum in the US and other countries. All other
product names are trademarks or registered trademarks of their respective owners.
P/N 1017477 Rev C
16 16
OF
Tape Drive Configuration
Single full height tape drive
Two full height tape drives
Single half height tape drive
Four half height tape drives
You may need to reconfigure your backup application to recognize the new tape drive.
Refer to your application's documentation for instructions.
I
NSTALLATION
Detect the library
View the library's cartridge inventory
Move tapes into and out of the tape drive
Detect the tape drive
Perform a Read/Write test
September 2009
Top tape drive
Bottom tape drive
Top tape drive
Third tape drive
Second tape drive
Bottom tape drive
www.tandbergdata.com
SCSI ID
3
4
3
3
6
5
4
3
#1017477C#