Advertisement
I
A
NSTALLING
DDITIONAL
!
Important
To install an additional tape drive (or tape drives), follow these steps:
1.
Preparing for replacement—
a.
Update library firmware to v. V1D181 or higher (see Important note above).
b.
Power off the host.
c.
Power off the library (press the 0 on the back of the unit).
d.
Disconnect the power cord, the SCSI or Fibre Channel cable(s), and the terminator (if one is installed).
e.
Remove the tape drive cover plate. Set the plate and the screws aside.
Figure 8
Tape drive cover plate (HH SCSI library)
2.
Removing the internal cooling plates and disconnecting cables—
!
Important
T
D
APE
RIVES
You must update your Magnum 448 library to the current firmware (v. V1D181 or
higher) before you install your new drive. The firmware allows the library to
auto-configure the tape drive installation upon power up, eliminating the step of
manually configuring the library after tape drive installation.
If your library code is not updated to v. V1D181 or higher, you will need to contact
Tandberg Data technical support for manual configuration instructions.
Back of
library
Remove as many internal cooling plates as necessary to add tape drives, but leave all
empty tape drive bays covered. The plates are required for proper cooling.
Screws
(4 each side)
Tape drive
cover plate
0
Power OFF (press the
)
Disconnect power cord
7
16
OF
Advertisement
Need help?
Do you have a question about the Magnum 448 and is the answer not in the manual?
Questions and answers