GE DMS Go Operator's Manual page 102

Chapter 3. Creating Data Recorder Files
Reading Type
Number of Locations
Location Label Length Sets the maximum length of the label identifying each location.
Points Per Location
Point Label Length
Custom Point
File Name
File
Units
T-MIN
T-MAX
Note: Setting the reading type to "extended" stores additional information with the thickness measurement, including: the time/date of
reading, time/date of last calibration, measurement mode, rectification, probe type, velocity and gain. Once stored, this additional
information is only accessible using UltraMATE®.
74
Your Complete Source for
Testing Equipment. Since 1969!
Table 3: Items to be Defined for Each File Type (cont.)
Set file style to Standard (normally recommended) or Extended.
Quantity of locations
Defines the number of points assigned to each file location.
Sets the maximum length of the label identifying each point.
16 character file name, set using the virtual keyboard. No two files in the DMS Go memory
may have the same file name.
Selects either inches or millimeters as the unit of measurement
Defines the minimum thickness limit. Measurements below this limit cause an alarm to signal.
Defines the maximum thickness limit. Measurements above this limit cause an alarm to signal.
www.BergEng.com
Berg Engineering & Sales Company, Inc.
DMS Go Operator's Manual
1-847-577-3980
Info@BergEng.com