Table of Contents
Advertisement
www.DataSheet4U.com
2.6
Power Up the Emulator
A power supply is included in the CE2000-H8S/2238 emulator package. It can accommodate 110-240V
50-60Hz AC supply. The unit is capable of a regulated 5V, 2.6A output.
The following diagram shows the polarity of the power-supply plug:
Connect the plug to the power input of the emulator. The Power LED lights up (red colour).
2.7
Checking the System (Standalone mode)
If the emulator is powered up and USB link to PC is not established within 10 seconds, it will go into self
test mode.
The POWER LED changes its colour from RED to ORANGE when it has entered the self test mode. This
test takes about 1∼2 minutes. At the end of the test, the POWER LED starts to blink. If the test fails, the
adjacent RUN LED lights up in RED. Otherwise, it remains unlit.
For more details about this test, please refer to section 8.
After the confirmation of the condition of the emulator, user has to insert the USB cable and power up
the emulator in order to link the emulator to the PC.
2.7.1 LED indication
Indication
Power Up
Self Test in Process
Self Test Fail
Self Test Pass
Running User Program
PC Detection
X : Don't Care
CENTRE POSITIVE
2.1 mm Phone - J
GROUND
+5V
Figure 2-16
Power–supply Plug
POWER LED
Red
Orange
Blinking Orange
Blinking Orange
X
Orange
ack
RUN LED
Nil
Red
Nil
Green
18
X
X
Advertisement
Table of Contents
