When Power Is Supplied To The User System From The Emulator (E1/E2/E2 Lite Only) - Renesas E1 User Manual

E1/E20/E2/E2 Lite Additional Document
3.1.2

When Power is Supplied to the User System from the Emulator (E1/E2/E2 Lite Only)

<When using the emulator>
(1) Connect the user system.
Connect the emulator and the user system with a user-system interface cable.
When the external trigger input/output function is to be used with the E2, connect the pins to be
used.
(2) Connect the host machine and turn on the emulator.
Connect the emulator and the host machine with a USB interface cable, then turn on the emulator.
(3) Launch the emulator debugger or programming software.
Launch the emulator debugger or programming software and select the setting of power supply to
the user system.
(4) Connect the emulator debugger or programming software to the emulator.
Connections may vary depending on software.
<When finished using the emulator>
(1) Disconnect the emulator debugger or programming software from the emulator.
Disconnections may vary depending on software.
(2) Close the emulator debugger or programming software.
Close the emulator debugger or programming software.
(3) Turn off the emulator and disconnect the emulator.
Disconnect the USB interface cable from the emulator, then turn off the emulator.
(4) Disconnect the user system.
Disconnect the user system interface cable from the user system.
When the external trigger input/output function is to be used with the E2, disconnect the pins that
were in use.
R20UT2937EJ0301 Rev.3.01
Jul 1, 2020
3. Notes on Usage
Page 34 of 45