Connection To Target System; Target Power Supply; Types Of User Interface Cable - Renesas CE2000-H8S Series User Manual

www.DataSheet4U.com
To change the setting, user has to:
•
Click on the Add button in the Memory Mapping dialog.
•
Key in the desired address at From and To.
•
Select the attribute.
For the details of the memory mapping, please refer to section 3.

2.11 Connection to Target System

2.11.1 Target Power Supply

The CE2000-H8S/2238 emulator has an automatic voltage follower. Once target is connected (target
connector's signal: CABLE_IN_N = Lo, refer to the Appendix A), the CE2000-H8S/2238 emulator will
operate at the user supply (2.5V−5V). Otherwise, it will operate at 5V. When target is connected, HEW
will indicate "User Cable : connected" in the status/ platform window.
NOTE:
•
Do not connect the user system interface cable to the emulator without user system connection (i.e.
without target user supply).
•
Turn on the user system before powering up the emulator.

2.11.2 Types of User Interface Cable

There are two ways to connect the target system to the CE2000 i.e.,
•
via an actual footprint user cable (purchase separately), or
•
direct connection using the KEL connectors (supplied in the package)
For the actual footprint user cable, user is advised to refer to the Microcomputer Hardware Manual for
the footprint information.
For the direct connection method, the connector information such as pin definitions, layout, dimensions
and part number are detailed in the Appendices A, B and C.
Figure 2-21 Editing the Memory Mapping
23