Section 2: Introduction; Related Documents; Specifications - Bennett CNG Spec. 100 Series Operator's Manual

Remote dispenser with 819 electronics

Table of Contents

Bennett CNG Spec. 100 Series Operators Manual

SECTION 2: INTRODUCTION

This manual contains the operation instructions used for the CNG Spec 100 Series Dispenser. Included are descriptions of various control

devices, how to operate the dispenser, programming, troubleshooting, and maintenance information. Please refer to any original

equipment manufacturer's operating instructions for proper operation. Contact Bennett Pump Technical Support for questions at 1-800-

423-6638.

SPECIFICATIONS

DIMENSIONS

CNG Series Maximum (width x depth x height) ................................................................................. 49" (width) x 22" (depth) x 91" (height)

CNG Series Base (width x depth) .................................................................................................... INSIDE – 43 3/8" (width) x 15 1/8" (depth)

CNG Series Estimated Shipping Weight (pounds / GGE) ......................................................................................................... 650 lbs. / 295 kg

ENVIRONMENTAL REQUIREMENTS

Operating and Storage Temperature .............................................................................................................. -40

Operating Humidity .................................................................................................................................................. 0 to 95% Non-Condensing

Storage Humidity ................................................................................................................................................. 30% to 70% Non-Condensing

Nominal Filling Pressure ....................................................................................................................................................... 3600 psi (248 bar)

Maximum Filling Pressure..................................................................................................................................................... 4250 psi (293 bar)

Maximum Flow Rate (light duty vehicles) ..................................................................................................

POWER REQUIREMENTS

DANGER:

INCOMING AC POWER AT TS1 OF THE TIMER BOARD WILL REMAIN ACTIVE IF THE MAIN CIRCUIT BREAKER(S) ARE

NOT TURNED OFF.

WARNING: TO PREVENT ELECTRIC SHOCK, MAKE SURE THE CURRENT IS OFF AT THE CIRCUIT BREAKER(S) AND THE BREAKER IS

LOCKED OUT BEFORE DOING ANY REPAIRS OR MAINTENANCE TO THE DISPENSER.

CAUTION: THE INTRINSIC SAFETY GROUND WIRE MUST BE FIRMLY MOUNTED TO THE DISPENSER CHASSIS TO INSURE

INTRINSIC SAFETY!

AC Power Input, Electronic .................................................................................................................115/230 VAC, 50/60 Hz. 350Watts Max.

DC Power Supply Outputs ........................................................................................................................................... +5VDC at 5.0 Amps Max.

Lead Acid-Cadmium Battery Output ........................................................................................................................ +12 VDC at 2.0 Amp Max.

Nickel Cadmium Battery Output....................................................................................................................... +3.6 VDC at 250 Milliamp Max.

Valance not included.

Introduction

OUTSIDE - 44 ½" (width) x 19 ¼" (depth)



C to +65

C / -40

†

up to 0.1323lbs (60 g) per second

+12 VDC 1.75 Amps Max.

+24 VDC 2.75 Amps Max.



F to +185