Hitachi HF-W2000 35 Setup Manual page 42

5. If the [y] key is pressed in response to the boot partition capacity change confirmation
message displayed in step 4, a message for entering the boot partition capacity is displayed.
Do you change the size of boot partition?
In case of "No",it is set to the default size (NNN MB).
(Yes[y]/No[n]):y
Input the size of boot partition by the megabyte[MB] and press
ENTER.
partition size(MIN-MAX[MB]):
The minimum (MIN) and maximum (MAX) values that can be input are displayed. Enter
the boot partition capacity in MB (1 MB = 1,048,576 bytes), and press the [Enter] key.
When the boot partition capacity is entered, an input confirmation message is displayed.
partition size(MIN-MAX[MB]):20000
Set the boot partition size to 20000 MB.
Continue?
(Yes[y]/No[n]):
If the [y] key is pressed, drive restoration is started, and the progress is displayed (skip to
step 6).
If the [n] key is pressed, the following message is displayed, and the change of boot
partition capacity is canceled. Press the power switch to cut power to HF-W.
(Yes[y]/No[n]):n
System recovery process is canceled.
If a value outside of the valid range of input is entered, the following message is displayed.
Enter another number.
Input error.
Input the size of boot partition by the megabyte[MB] and press
ENTER.
partition size(MIN-MAX[MB]):
6. If the [y] key is pressed, drive restoration is started, and the progress is displayed.
HJ-203**E*E* system recovery START.
xx%
3. USING THE RECOVERY DVD TO RESTORE FACTORY SETTINGS
3-5