Table of Contents
Advertisement
Echoflex Installation Guide
Light Sensor
5.
Thread the appropriate washer and nut (two sizes included) onto
either the head or the extension adapter (if used), securing it in place.
Terminate Sensor Head Control Wiring
1.
Terminate the incoming wire from the controller to the head leads
using wire nuts or other wire termination (not provided).
a.
b.
c.
2.
Terminate the incoming wire pairs from the remote Light Sensor head
to the controller.
a.
b.
c.
d.
e.
Sensor Configuration
The Elaho Light Sensor participates in an Elaho
system using the configured Space and Address,
which you set using the rotary switches on the rear
panel of the sensor.
Additional DIP switches and the [MODE] button,
also located on the rear panel, set the sensor
functionality and the sensor function with dark
and bright actions.
Light Sensor
Strip each wire to the appropriate length, depending on the wire
nut or other wire termination used (wire nuts are not provided).
Twist the installed (typically black) Belden 8471 incoming wire
and the black lead from the head together and secure using a
wire nut or other wire termination.
Repeat for the installed (typically white) Belden 8471 wire and
remaining wire lead.
At the controller, strip 9-10 mm (5/8 in) of insulation from the
ends of each installed head wire.
Using a small 3.35 mm (1/8 in) flat blade or #1 Phillips
screwdriver, loosen the terminals on the "Primary Sensor" and
"Optional Sensor" connectors found on the Light Sensor
controller.
Insert the black (typical) wire from the first Light Sensor head wire
pair into terminal "1" of the "Primary Sensor" connector.
Insert the white (typical) wire from the first Light Sensor head wire
pair into terminal "2" of the "Primary Sensor" connector.
Repeat this process for the second wire pair, if installed, to the
"Optional Sensor" connector.
Page 8 of 12
Echoflex
Advertisement
Table of Contents
