Table of Contents
Advertisement
ETC Installation Guide
Step 4:
Step 5:
Step 6:
Sensor Configuration
The Echo Occupancy/Vacancy Sensor participates in an Echo system using the
configured Space and Address, which are selectable using the rotary switches
on the rear panel of the sensor.
Additional DIP switches and the [Mode] button, also located on the rear
panel, set the sensor functionality and the occupancy detected action.
Set Space and Address
Two rotary switches on the rear panel of the controller provide for assignment
of the sensor Space and Address. By default, these switches are set to Space 1,
Address 1. Commands are shared by all devices within a given space.
Step 1:
Step 2:
Note:
Echo Occupancy/Vacancy Sensor
Orient the smooth side of the mounting plate to the finished
side of the ceiling tile and align and insert the soft ceiling tile
adapter through the holes provided near the center of the
mounting plate. Reference the graphic on the previous page.
Poke the tines of the adapter through the ceiling tile, then
bend each tine over in opposite directions for a secure fit on
the unfinished side of the ceiling tile.
Strip each wire 5/16" (8mm) and terminate the EchoConnect
(white and black wires) and ground wire (green/yellow) to the
EchoConnect terminal block located on the sensor control
board. Torque each termination to 3.1-3.5 in-lb.
a: Terminate the white incoming wire to the data +
terminal.
b: Terminate the black incoming wire to the data - terminal.
c: Terminate the green/yellow (ground) wire to the labeled
ground terminal.
Set the Space rotary switch to the desired number (1 thru 16)
for the space you want the sensor to control.
Set the Address rotary switch to desired address (1 thru 16) for
the sensor identification in the selected space.
Do not duplicate a device Address within the same Space.
Page 6 of 12
Occupancy/Vacancy Sensor
Electronic Theatre Controls, Inc.
Advertisement
Table of Contents
