Table of Contents
Advertisement
Signal Processor Battery Status: Discharge
To check battery status on signal processor,
1.
Quickly press the On/Off button on signal processor.
2.
Battery indicator lights will light indicating current battery status.
SP-BLE Battery Indication
1 green light is blinking
Signal processor battery status can also be found on the display screen as
shown in Symbol 11 of Figure 3.
Placing Device in Long-Term Storage Mode
When not using device daily or for storing for long periods of time, battery life
can be extended by placing the system into Long-Term Storage Mode.
1.
Press and hold On/Off, Sleep button on display until screen prompt
appears
2.
Choose "Power Off" on screen. Screen will go black. Display is now in
Long-Term Storage Mode.
3.
Press and hold the On/Off button on the signal processor until all signal
processor lights flash simultaneously. Signal processor is now in Long-
Term Storage Mode.
To take system out of Long-Term Storage mode for use, follow steps 2-5 in
"Initial System Set-Up" section on page 24.
Data Download
Session data can be downloaded from the display onto a memory stick.
NOTE: Data can only be downloaded via download cable and memory stick.
Data cannot be downloaded directly from device by use of included charging
cable.
1.
Plug USB memory stick into download cable and insert data download
cable connector into the charging port of display.
28
3 green lights are lit
2 green lights are lit
1 green light is lit
No lights
Battery Level
High (60-100%)
Medium (20-59%)
Low (5-19%), charge SP
Critical (0-4%), charge SP
Depleted or Off
System Operation
Advertisement
Table of Contents
