System Menu; Adjusting The Lcd Screen Brightness; Setting The Initial Slow Mode State - adept technology T2 User Manual

Operation

4.16 System Menu

The System Menu provides the following functions:
• Adjust the LCD screen brightness (see
• Set the initial Slow mode state (see
• Enable/disable the LCD screen saver (see
• Calibrate the LCD touchscreen (see
• Clean the LCD touchscreen (see
• Install a firmware update (see

Adjusting the LCD Screen Brightness

The Brightness control (slider) allows you to adjust the LCD screen brightness for
optimum viewing in your environment.
• To darken the display (make it dimmer), move the Brightness control to the left.
• To lighten the display (make it brighter), move the Brightness control to the right.
When you have completed the adjustment, press OK to save your setting.

Setting the Initial Slow Mode State

The Initial Slow Mode State button allows you to specify the state of the SLOW mode
button at pendant startup. The Initial Slow Mode State button has three modes:
• Do Not Change - leaves the current SLOW mode button state unchanged
• Force On - toggles the SLOW mode button so that slow mode is enabled
• Force Off - toggles the SLOW mode button so that slow mode is disabled
38
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Adjusting the LCD Screen
Setting the Initial Slow Mode
Section 5.2 on page
Section 5.3 on page
Section 5.1 on page
Figure 4-10. System Menu Screen
Adept T2 Pendant User's Guide, Rev D
Brightness)
State)
Setting the Screen Saver)
43)
44)
41)