adept technology T2 User Manual page 23

Operation
Table 4-1. Overview of Main Screen Functions (Continued)
STEP In Manual mode, press STEP to initiate motion in a program. See
page 36.
SLOW Selects between the two different speed ranges of the speed bar. When the SLOW
button indicator bar lights, the slow speed range is selected. The slow speed range
is from 0 to 25% of the normal pendant speed. Press the SLOW button again to
return to normal speed.
F1, F2, Programmable function buttons, used in custom application programs. When the
DEV/F3 system contains more than one robot, the DEV/F3 button selects which robot is
active.
COMP If high power is enabled and the system is in Manual mode, this button selects
PWR Computer mode. If the system is in AUTO mode and high power is disabled, this
button starts the enable high power sequence and selects Computer mode. See
Section 4.5 on page
Number To enter data, similar to the numeric keypad on a standard keyboard.
keys 0-9
DEL Acts like the backspace key on a standard keyboard. When data is being entered, it
will appear in the pendant display. DEL will delete any characters that appear on
the pendant display but have not been entered using the REC/DONE button.
Application programs may also assign special functions to the DEL button
YES+/NO- When T1 button is selected, press YES/+ to open, NO/- to close the gripper. Also
used to respond to questions from a program.
T1 Pressing enables the gripper open/close function, if solenoids are installed - see
YES/NO above. See
PROG SET Used to select a new program, and set parameters. See
ROBOT: Displays which robot is being controlled by the pendant.
MODE Mode Display area shows active mode: Comp, World, Tool, Joint, or Free. Lack of
Display any mode indicates Off mode.
Area
Speed Bar Sets the robot speed, as a percentage of maximum speed. The speed value is
displayed at right side. Press and drag slider to desired speed, or press the bar
where you want the speed to be.
SYS MENU Opens System Menu dialog box, to adjust screen brightness, calibrate
touchscreen, clean the screen, and update firmware. See
Section 4.16 on page
USER Box in upper left corner, dark when not active. When User indicator lights up,
indicates that an application program is making use of the pendant. When User
indicator blinks, indicates an application program is suspended. Press Rec/Done to
resume program operation.
22
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
26.
Section 4.14 on page
38.
Adept T2 Pendant User's Guide, Rev D
Section 4.13 on
37.
Section 4.12 on page 35.