Installation In A Smartcontroller System - adept technology T2 User Manual

Installation
2.2

Installation in a SmartController System

1. Plug the pendant cable connector into the matching adapter cable connector.
NOTE: The T2 pendant uses push-pull connectors. Line up the red dots to
insert the connectors, pull back on the outer sleeve to remove.
2. If you are using an equipment cabinet, the adapter cable connector can be
bulkhead-mounted to the inside wall. See
3. Plug the adapter cable into the XMCP connector on the SmartController.
Equipment Cabinet
(user-supplied)
T2 Pendant
From T2 Pendant
Figure 2-1. Installing Pendant in Equipment Cabinet
14
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
R
Sma rtS ervo
Device Net Eth 10/100
OK HPE LAN 1.1 1.2 RS-232
SF ES HD SW1
1 2 3
XDIO XS YS XFP
XUSR
Bypass Plug
(supplied
with pendant)
Wall or door of
equipment cabinet
Push-Pull connector: to remove,
pull back on outer sleeve.
Red Dot
SW 22.6
Figure 2-2. Panel Cut-out Dimensions
Adept T2 Pendant User's Guide, Rev D
Figure 2-2 Panel Cut-out
SmartController
RS-422/485
XMCP
XDC1 XDC2
24V 5A
-+ -+
D-Sub
Bypass Plug
(supplied with controller)
T2 Adapter Cable
(supplied with T2 Pendant)
To controller
∅ 24.1
Dimensions.