Changingthe Oil - International H-400C Operator's Manual

Pay loader
Table of Contents

Advertisement

SECTION
8
MAINTENANCE
Page 28
TRANSMISSION
AND TORQUE
CONVERTER
CHANGING
THE FILTER
ELEMENTS
- Continued
Removal - Continued
5. Pull the case (14) free of the head (5) and lower the case-
and element
as a unit.
6.
Turn the case upside down and drain the oil out.
7. Remove and discard the element (8) and two seals (7). Be
careful not to lose the spring (13), washer (12), cap (11) and
seal (10) from the bottom of the case.
8. Place the spring (13), cap (11
L
washers (2 and 12), bolt
(1)
and case (14) in a solvent bath. Wash out any sludge that has
accumulated in the case. Wipe the inside of the head
(5)
out.
Dry all parts thoroughly.
9.
Check the condition of the large seal
(6)
in the head and
small seal (10) from the case. Replace them if they show
signs of wear or deterioration.
Installation (illust. 37)
1. Preassemble the following parts in the order given:
a. Insert the spring (13), cap (11), washer (12) and small
seal (10) over the shaft in the case and push them to the
bottom.
b. Install the element (8) with seals
(7)
into the case.
Push the element down and seat it over the seal (10).
2. Position the preassembled parts so the case seats squarely
into the head.
3. Install the washer (2) on the bolt (1) and insert the bolt
into the head
(5).
Tighten the bolt into the case.
4. After servicing both filters, start the engine and let it idle
for approximately
five minutes. During this time, check for
filter leaks. Correct any leak.
5.
Check the transmission
oil level as described
under
"CHECKING THE OIL LEVEL."
CHANGING THE OIL
1. After reaching operating temperature, park the machine on
level ground. Lower the bucket to the ground, apply the park-
ing brake and shut the engine down.
1. Bolt.
2.
Washer.
3. Plug.
4. Valve.
5. Head.
@,--7
9
-8
,
"
"
,-----' - ::.--7
@
®_10
©>
12
@-11
__
13
~-'4
LJ
CE-JOS738
lIIust.37
Transmission and Torque Converter Oil Filter.
6.
Seal.
11. Cap.
7. Seal.
12. Washer.
8. Element.
13. Spring.
9.
Element Assembly.
14. Case.
10. .Seal.
u
u
u

Advertisement

Table of Contents
loading

Related Products for International H-400C

Table of Contents