Table of Contents
Advertisement
•
•
•
•
•
INSTRUMENTS
AND
CONTROLS
SECTION 3
NOTE: A low air pressure warning buzzer will sound until
the air pressure reaches60 psi.
®
Torque Converter Oil Temperature Gauge
This gaugeregistersthe temperature of the fluid in the torque
converter. After the enginehasoperated sufficiently to reach
a stabilized torque converter temperature, tap the gauge
lightly and check its reading. The gaugemust register in the
"RUN" (green) area. The left side of the "RUN" segmentis
approximately 100 degreesF. andthe right side approximately
250 degreesF.
If the gaugeregistersin the "CHECK 01 L" segment,shift the
transmission to a lower gear range and reduce engine speed.
If this fails to bring the temperature into the "RUN" seg-
ment, proceed as follows:
a. Stop the engine. Check the oil level in the transmis-
sion (refer to Section 7 for the correct level checking
procedure).
b. Service the transmission filter. For filter servicing
procedures, refer to "CHANGING THE FI LTER ELE-
MENT" under "TRANSMISSION AND TORQUE CON-
VE RTER" in Section 8.
NOTE: Continual high fluid temperatures should be
corrected before resumingto operate the machine.
Page
3
0----
®
Combination Switch (lilust. 2)
A Position - Off
This position is used to stop the engine. There is no
electrical current flow to any circuit when the combina-
tion switch is in this position.
B Position - Ignition
This switch position allows electrical current to flow to
the ignition circuit. The combination switch must be in
one of the ignition positions (B, C or D) before the en-
gine can be started or cranked.
/
/
/
8
CE-105327
lIIust. 2
Combination Switch Positions.
A.
Off.
B.
Ignition.
C.
Instruments and Front Driving Lights.
D.
Instruments and Front and Rear Driving Lights.
C Position - Ignition, Instrument Lights, Tail Lights
and Front Driving Lights
The instrument panel lights, tail lights and front driving
lights will be on when the combination switch is in this
position. The engine may also be started in this switch
position.
D Position - Ignition, Instrument Lights, Tail Lights
and Front and Rear Driving Lights
The instrument panel lights, tail lights, front and rear
driving lights will be on when the combination switch is
in this position. The engine may also be started in this
position.
®
Starter Switch
Turn the combination switch to the ignition position and
pressthe starter switch to crank the engine. After the engine
starts to run, releasethe starter switch.
NOTE: Never pressthe starter switch while the engine is
running. This will damage the cranking motor and the
engine flywheel.
PRINTED
IN UNITED
STATES OF AMERICA
Advertisement
Table of Contents
