International H-400C Operator's Manual page 54

•
•
•
•
•
SCHEDULED MAINTENANCE
SECTION 7
Page9
Item 4 - Hydraulic ReservoirOil Level
SERVICE POINTS
Checking Oil Level
Check the hydraulic system oil level at the sight gaugeon the
front side of the hydraulic oil reservoir with the bucket
resting flat on the ground. The ball inside of the sight gauge
must be floating in the window of the gauge.If the ball is not
floating, add oil as described under "HYDRAULIC
SYSTEM" in Section 8.
lIIust. 3
ReservoirSight Gauge.
ChangingOil
Change the oil. Refer to "HYDRAULIC SYSTEM" in
Section 8.
Item 5 - Drive Shafts
Converter To Transmission
(Two fittings) - Apply the lubricator to each spider fitting
until clean lubricant appears .
TransmissionTo Transfer Drive
(Three fittings) - Apply the lubricator to each spi~Elrfitting
and to the slip yoke fitting until clean lubricant appears.
Transfer Drive To Front Axle
(Three fittings) - Apply the lubricator to each spider fitting
and to the slip yoke fitting until clean lubricant appears.
TransmissionTo RearAxle
(Three fittings) - Apply the lubricator to each spider fitting
and to the slip yoke fitting until clean lubricant appears.
Item 6 - Upper And Lower Articulation Pivots
(Two fittings) - Apply the lubricator to each fitting located
on the frame ears until clean lubricant appearsbetween the
frame tongues.
Item 7 - Steering Cylinders
(Two fittings on each cylinder) - Apply the lubricator to the
fittings on each end of the cylinder until clean lubricant
appears.
Item 8 - Boom Pivots
(Two fittings on each boom arm) - Apply the lubricator to
the fittings on each end of the boom arm until clean
lubricant appears.
Item 9 - Bucket Cyl inders
(Two fittings on each cylinder) - Apply the lubricator to the
fittings on each end of the cylinder until clean lubricant
appears.
Item 10 - Bellcrank Pivots
(Two fittings) - Apply the lubricator to the fittings located at
the inside of each bellcrank arm near the top of the cross
shaft until clean lubricant appears.
Item 11 - Bucket link Pivots
(Two fittings on each link) - Apply the lubricator to the
fittings located at each end of the bucket links until clean
lubricant appears.