International H-400C Operator's Manual page 19

SECTION 3
INSTRUMENTS AND CONTROLS
•
Page8
Solid BaseSeat Adjustment (Standard) (lliust. 7)
For operator's convenience in reaching the controls and
improved operating visibility, the operator's seat can be
adjusted to various positions.
One seat adjustment lever is attached to the bottom front
side of the seat. To adjust the seatforward or backward, pull
the lever (1) and slide seat in the desireddirection. The lever
(2) on the left side of the seat pedestalallows the seatto tilt
forward or back. Pull up on the tilt lever to adjust the tilt of
the seat. The height can be adjusted by removing the two
bolts (3) that secure the inner post to the outer post and
lining up the holes in both posts at a higher or lower setting.
Be sure to replace the two bolts with the headsof the bolts
towards the front of the seat.
lIIust. 7
Solid BaseSeatAdjustments.
1. Forward or Back Positioning Lever.
2. Tilt Lever.
3. Height Adjustment.
Air SuspensionSeat Adjustment (If equipped) (Illust. 8)
The air suspension seat has an air shock absorber which
receives compressed air from the machine air system. This
allows the operator to adjust the firmness of the seat
suspension by regulating the amount of air in the shock
absorber.The seatadjustments are madeasfollows:
•
CAUTION: DO NOT ADJUST THE SEAT
WHILE THE MACHINE IS IN MOTION.
1. Pushair control knob (1) in to get a more firm ride or pull
it out to get a softer ride.
2. Pushsidelever (2) back to release.Slide the seatforward or
back to the desired position, then releasethe lever.
3. Lift up handle (3) to releasethe tilt catch. Position the
seat at the desired tilt angle and push the lever down to lock
in position.
•
NOTE: Do not adjust the tilt while sitting in the seat.
4. To raise the seat turn knob (4) clockwise; to lower
counterclockwise.
Check and tighten bolts periodically to prevent excessive
bushing wear.
•
•
lIIust. 8
Air SuspensionSeat Controls
1. Air Control.
2. Forward and Rear Control.
3. Tilt Control.
4. Height Adjuster.
•