Table of Contents
Advertisement
•
•
•
•
•
INSTRUMENTS
AND
CONTROLS
SECTION 3
AUXILIARY INSTRUMENTS (If equipped) (lilust. 4)
The auxiliarv instruments are located to the right of the
operator's seaton the cabwall. The instruments are asfollows:
Item, numbers correspond with numbers shown in
I II
usf.
4.
IIlust.4
Auxiliary Instruments.
1. High EngineCoolant Temperature Warning Light.
2. TransmissionClutch Oil PressureGauge.
3. Low' Engine Oil Pressure Warning Light.
4. Instnument Panel Light.
5. Hydraulic Oil PressureGauge.
Page5
CD
High Engine Coolant Temperature Warning Light
The high engine coolant temperature warning light will come
on if the engine coolant temperature exceeds200 degreesF.
If the light comes on, shut the enginedown immediately and
correct the causeof overheating.
CD
TransmissionClutch Oil PressureGauge
This gaugeregistersthe pressureof the oil being delivered to
the clutch packs in the transmission. The gauge should be
connected only when pressurechecks are being made. After
the engine has operated a sufficient length of time, the gauge
must register 240-260 pounds of pressure. If the pointer is
below or above the normal operating pressure,stop the en-
gineand servicethe transmission oil filters. Refer to "TRANS-
MISSION AND TORQUE CONVERTER" in Section 28.
If, after servicing the filters, the pointer still registersbelow
or above the normal operating pressure,stop the engine and
consult your authorized International Construction Equip-
ment distributor or dealer before operating the machine. This
gaugeshould be disconnected when checksare completed, as
the extreme pressurechangesto which the gaugeis subjected
will greatly reduce the gaugelife.
CD
Low Engine Oil PressureWarning Light
The low engine oil pressurewarning light will come on if the
oil pressuredrops below 15 psi. If the light comeson, shut the
enginedown immediately and correct the cause of low oil
pressure.
CD
Instrument Panel light
The auxiliary instrument panel light will come on when the
combination switch is placed in C or D position. Refer to
"Combination Switch" and Illust. 2 in Section 3 under
"INSTRUMENTS AND CONTROLS."
®
Hydraulic Oil Pressure Gauge
This gaugeregistersthe pressureof the oil being delivered to
the main hydraulic valve. The gaugeshould be connected only
when pressurechecks are being made. The gaugeshould give
a pressurereading of 3000 psi maximum.
Advertisement
Table of Contents
