Table of Contents
Advertisement
SECTION 2
BEFORE
STARTING
THE
NEW
MACHINE
Page 2
LUBRICATION
WHEN SHIPPED
This machine has been lubricated at the factory for operation
in an air-temperature
range of -10 degrees F. to 110 degrees
F. If the machine is to be operated above or below this
range, change to the correct lubricants. Unless an exception
is shown below, all lubricants
can be used (within
above
temperature
range) until regular scheduled (normal) change
interval occurs. Refer to "SERVICE
GUIDES"
in Section 7
for the scheduled (normal) change intervals and to "LUBRI-
CANT SPECI FICATIONS AND CAPACITIES"
for the proper
oil grades for various air temperatures.
Compartment
Lubricant
Crankcase
EO
(£)
Hydraulic Reservoir
EO
@
Transmission
EO
®
Transfer Drive
MPL
Axles
MPL
®
The crankcase has been filled with the type and vis-
cosityof oil asspecified by Cummins Engine Company. Refer
to your Engine Operator's Manual for the length of time this
oil can be usedbefore draining.
o
After the initial 100 hours of operation, replace the
hydraulic oil filters. Thereafter, service these filters at the
intervals specified in the "SCHEDULED MAINTENANCE
GUIDE" in Section 7.
u
®
After the initial 100 hours of operation, change the
transmission oil filter element and clean the transmission
sump strainers. Thereafter, changethe oil filter element and
clean the sump strainers at the intervals specified in the
"SCHEDULED
MAINTENANCE GUIDE"
in Section 7.
Advertisement
Table of Contents
