Table of Contents
Advertisement
•
•
•
•
•
MAINTENANCE
SECTION 8
Page21
FUSE REPLACEMENT
ELECTRICAL SYSTEM
If a short circuit occurs in a circuit, the fuse will burn out
and break the circuit, preventing damage to the electrical
system.
It is important to usethe samecapacity fuse for replacement.
Refer to your machine parts catalog for the proper replace-
ment fuse. If the lights fail, check the fuse. If the fuse con-
tinually burns out, check the electrical wiring for short cir-
cuits.
Fuse Holders in Instrument Panel
To replacea blown fuse, unscrewthe fuse holder cap and pull
the fuse out. Refer to "INSTRUMENTS AND CONTROLS"
in Section 3 to determine which fuse protects which circuit.
STOP LIGHT SWITCH (lilust. 26)
To check the stop light switch for proper operation, the air
pressuregaugemust be in the "RUN" area. Station a helper
at the rear of the machine to observethe stop lights. Depress
one of the brake treadles. The stop lights should go on. If
not, check for and correct the problem. Possible trouble
areas may be the fuse, burned-out bulbs, or the stop light
switch.
lIIust.26
Stop Light Switch.
lIIust. 27
CrankcaseOil Drain,
ENGINE
Refer to your Cummins Engine Operator's Manual for all
maintenance and lubrication to be performed on the engine.
NOTE: The engine lubricating oil drain is located at the
lower right corner of the fuel tank (illust. 27).
Advertisement
Table of Contents
