International H-400C Operator's Manual page 57

SECTION 7
SCHEDULED MAINTENANCE
Page12
SERVICE POINTS
Item 14 - Transfer Drive Lubricant
Checking Lubricant Level (lIIust. 7)
The transfer drive is located in the front frame just aheadof
the articulation area.
lIIust. 7
Transfer Drive Fluid Level Gauge.
1. Park the machine on level ground.
2. Turn the "T" handle on the dipstick counterclockwise to
loosen it.
3. Remove the dipstick and check the lubricant level on the
gauge. If the lubricant level is below the "FULL" mark, add
enough lubricant to bring the level up to the mark. Refer to
"LUBRICANT SPECIFICATIONS AND CAPACITIES" in
this section for the type of lubricant specified.
4. Install the dipstick in placeand tighten the "T" handle.
Changingthe Lubricant
1. Remove the dipstick by turning the "T" handle
counterclockwise.
2. Remove the drain plug and copper washer from the
bottom of the transfer drive body.
3. Allow the lubricant to completely drain.
4. Clean the plug and washer in solvent and dry thoroughly. •
Jl
If the washeris damaged,replaceit. '-'
5. Install the washerand plug.
6. Fill the transfer drive body with fresh lubricant. Refer to
"LUBRICANT SPECIFICATIONS AND CAPACITIES" in
this section for the type of lubricant specified.
7. Check the lubricant level. If low, add lubricant to the
proper level.
8. Install the dipstick.
Item 15 - Boom Cylinders
(Two fittings on each cylinder) - Apply the lubricator to the
fittings located at each end of the cylinders until clean
lubricant appears.
Item 16 - TransmissionOil
Checking Oil Level
Refer to "TRANSMISSION AND TORQUE CONVERTER"
in Section 8.
Changingthe Oil
Refer to "TRANSMISSION AND TORQUE CONVERTER"
in Section 8.