Electrical System Components; Microswitch: Seat; Microswitch: Mowing Deck; Microswitch: Pedal Arrangement - Husqvarna Rider 111 B Workshop Manual

Electrical system

Electrical system components

The electrical system consists of four cables, three
microswitches, one ignition switch and one fuse. If
the mower does not start (the start engine does not
rotate when the key switch is turned to the starting
position), one of the electrical system components
might be damaged. A description of how to replace
these components is found below.

Microswitch: Seat

1 Fold the seat upwards and remove the spring
disc with spring and spacer tube.
2 Disconnect the cable connections from the
microswitch.
3 Press in the fasteners and remove the
microswitch from the holder.
Assembling is done in the reverse order without
setting.
44
– English

Microswitch: Mowing Deck

1 Loosen the right-hand wing cover.
2 Release the connector from the microswitch.
3 Remove the microswitch.
Assembling is done in the reverse order without
setting.

Microswitch: Pedal arrangement

1 Remove the front cover.
2 Check that the microswitch is activated when
the brake pedal is pressed all the way down.
Otherwise, replace the microswitch. The switch is
held by the screw at the arrow.
3 Refi t the front cover.