Battery - Husqvarna Rider 111 B Workshop Manual

Delivery measures

Battery

WARNING!
Measures for contact with acid
External: Rinse thoroughly with water.
Internal: Drink large quantities of water or
milk. Contact a doctor as soon as
possible.
Eyes: Rinse thoroughly with water.
Contact a doctor as soon asap. The battery
gives off explosive gas. Sparks, naked
fl ames and cigarettes must absolutely not
be in the near vicinity of the battery.
Starting the engine with a weak battery
If the battery is too weak to start the engine, it
should be recharged. Charge the battery for 4 hours
at max. 3 amp.
When the battery is fully charged, connect the red
cable to the positive pole (+pole) of the battery and
the black cable to the negative pole (-pole). Ensure
that the red (+) cable is drawn behind the black (-)
cable.
When jump leads are used for emergency starting,
follow the procedure below:
10
– English
Connecting the jump leads
IMPORTANT INFORMATION
Your Rider is equipped with a 12-volt
system with negative earth. The other
vehicle must also have a 12-volt system
with negative earth. Do not use your Rider
battery to start other vehicles.
• Connect each end of the red cable to the
POSITIVE pole (+) on each battery, exercise care
not to short circuit any of the ends against the
chassis.
• Connect one end of the black cable to the
NEGATIVE pole (-) on the fully charged battery.
• Connect the other end of the black cable to a
good CHASSIS EARTH, away from the fuel tank
and the battery.
Remove the cables in the reverse order
• The BLACK cable is removed from the chassis
and then the fully charged battery.
• Finally the RED cable from both batteries.