Replacing Steering Wires - Husqvarna Rider 111 B Workshop Manual

Reparation instructions
1

Replacing steering wires

1 Release the steering wires' rear attachment (1).
2 Remove the frame cover by loosening the
screws. 3 screws at the front and 2 underneath
the seat.
3 Make a note of how the cable is laid out. Loosen
the front attachment (2) of the steering cables
at the steering chain (3), loosen the steering
cable wheels (4) and pull the steering cables out
through the frame.
Note. If the old wires are still complete, the new
wires can be attached to the old ones when they
are pulled out through the frame, the new wires
will then come automatically into place.
20
– English
2
4
4 Ensure that the steering wheel is in the centre
position when the rear wheels are centred. Re-
set the chain on the steering column's sprocket
or adjust the rear fi xture (1) for the steering
cables as needed.
Hold the cables with, for example, a wrench
when mounting so that they do not twist.
Attach the new wires. Once the new wires are
in place, check the wire tension (see "Checking
and adjusting steering wires").
8
7
6
3
5