Husqvarna Rider 111 B Workshop Manual page 36

Reparation instructions
3 Press the wire casing in the front holder in the
middle bracket.
4 Screw tight the hydrostatic transmission wire's
clamp.
5 Place the hydrostatic cable at the lowest position
in the fork below the pendulum shaft.
34
– English
6 Screw tight the linkage on the lower part of the
transmission wire.
1
7 Put the wire in position and screw tight the
casing with the rear clamp. (3).
8 Adjust the wire as directed in "Inspection and
adjustment of speed regulator".
Connect the rear linkage and fi t the lock spring
(2).
Tighten the rear lock nut (1) for the linkage.
3
2