Husqvarna Rider 111 B Workshop Manual page 30

Reparation instructions
5
13 Loosen the two screws (4) using a half-inch
wrench. Loosen the screw (5) behind the muffl er
and the screw (6) holding the exhaust pipe. The
belt guides can now be removed.
IMPORTANT INFORMATION
When assembling, the gasket between
the muffl er and the exhaust pipe must be
replaced.
28
– English
4
4
6
14Jack up the front carriage in front of the cable
pulley without squeezing any cables. Jack up the
rear carriage in the rear edge.
15 Use a slide hammer size M8 to loosen the
articulated shaft and the deck belt pulleys.
16 Separate the front and the rear carriage.