Removal/Installation Of Wire Wheel - Husqvarna Rider 111 B Workshop Manual

Reparation instructions
1

Removal/installation of wire wheel

1 Detach the steering wires' rear attachment (1).
2 Remove the screw (2) and detach the wire wheel
(5).
3 Remove the bearing's circlip (3) and knock out the
bearing (4).
4 To install the wire wheel, the reverse order is
applied.
The bushing (6) is to be placed between the
frame and the cable pulley.
22
– English
7
6
5
4
3
2
Ensure that the cables are properly placed in the
steering cable pulleys (7).
Ensure that the steering wheel is in the centre
position when the rear wheels are centred. Re-
set the chain on the steering column's sprocket or
adjust the rear fi xture (1) for the steering cables as
needed.
Hold the cables with, for example, a wrench when
mounting so that they do not twist.
After installation, check the wire tension (see
"Checking and adjusting steering wires").