Advertisement
To activate the device, plug it into a mains socket. Once it's connected to an active power source, it will turn
on automatically.
During start up, 'WELCOME' will be shown on the display, which means the device is not yet ready to be
operated. Once the device has fully started up, it will jump to the last-used mode. Operation modes and
other settings shown on the display can now be adjusted or changed by means of the menu buttons.
Should the device detect a DMX signal, it will automatically switch to DMX mode and will display the last-
used address. For new devices, this will normally be DMX address 001. Of course, you can change the DMX
address via the display using the menu buttons.
Using the display and the menu buttons, you can adjust the functions and settings of the device. Press
'Enter' to confirm an adjustment or select a function, use 'Up' and 'Down' to change values press 'Menu' to
go back to the menu.
Changed settings or functions can be confirmed by pressing 'Enter'. After several seconds, the device will
automatically return to the main menu and perform its actions. This process can be sped up by holding down
the 'Menu' button for two seconds after confirming changes with 'Enter'.
The menu contains the following options and settings:
Display
Mode
DMX address
DMX Addres Configuration
DMX MODE
Channel Mode Selection
AUTO MODE
Show mode with adjustable
speed and programs. Here, '00'
is a random program
Slave mode
Master / Slave mode: The master
device will provide slave devices
with a synchronised signal
Advanced
Advanced Settings
settings
You'll find an explanation of the various functions below:
DMX Address: With this function, you can determine the DMX start address of the device. Set it channel
001, and the device will read DMX channel 1. Set it to channel 003, then the device will read DMX channel 3,
etc.
DMX mode: This device can make use of different DMX channel modes. There's a simplified channel mode
for when your DMX circle is rather complete and no extensive control over the functions is required. It's also
possible to use the most extensive channel mode, allowing for more available channels, each with a different
a s s i g n e d
Auto mode: the device comes with multiple pre-programmed shows that operate at a fixed speed or, if
The information in this user manual is subject to change at any time without notice.
Version: 1.0
Date of creation and author's initials: 07-10-2019 RV
Operation and Mounting
Function
Address A001 ... A512
6CH / 9CH / 21CH / 30CH
Show mode: 00-12
Show speed: 01-99 (Slow-fast)
Sound mode: on/off
Sound sense: 00-99 (Sound Sensitivity min-
max)
Master
Slave 1
Slave 2
Dimmer mode: Halogen, Linear, Square,
Inverted Square, S-curve
Display: On/Off (for when not in use)
Display invert: No / Yes
LED calibration: Red, Green, Blue, White 050-
255
Language: English, Chinese
DMX fail: Auto, Blackout, Hold
Software: Display software version
Revision date and author's initials: -
f u n c t i o n .
Advertisement
