Advertisement
The device does not respond well
to DMX-commands.
The operating mode can not be
changed
The information in this user manual is subject to change at any time without notice.
Version: 1.0
Date of creation and author's initials: 07-10-2019 RV
Signal loss or interference in the
DMX circle
Wrong DMX-channel mode
The device is in Slave mode
Close the DMX circle with a
terminator or connect a booster
after maximum 32 fixtures.
Check to see if the correct DMX
channel mode is set.
If the device is in Slave mode, it
will wait for a master signal unless
there is a DMX signal present. Set
the device to Master to activate the
sound-controlled or automated
operation modes.
Revision date and author's initials: -
Advertisement
