Replacing The System Battery - Dell PowerEdge 700 Installation And Troubleshooting Manual

b. Grasp the expansion card by its top corners, and carefully remove it from the expansion- card connector.
NOTICE: You must install a filler bracket over an empty expansion slot to maintain Federal Communications Commission (FCC) certification of the
system. The brackets also help keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.
7. If you are removing the card permanently, install a metal filler bracket over the empty expansion slot opening and close the expansion-card latch.
8. Install the cover. See "Replacing the
9. Stand the system upright.
10. Install the bezel. See "Installing the
11. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
System Battery
The system battery is a 3.0-volt (V), coin-cell battery.

Replacing the System Battery

CAUTION: See your System Information Guide for complete information about safety precautions working inside the computer and protecting
against electrostatic discharge.
CAUTION: There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or equivalent type
recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions. See your System Information Guide for
additional information.
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Remove the bezel. See "Removing the
3. Lay the system on its right side.
4. Remove the cover. See "Removing the
5. Remove the expansion card(s) in slot 1 and slot 2 (if applicable). See
6. Remove the system battery. See Figure 6-10.
See Figure A-3 to locate the system battery on the system board.
You can pry the system battery out of its connector with your fingers or with a blunt, nonconductive object such as a plastic screwdriver.
7. Install the new system battery with the side labeled "+" facing up. See Figure 6-10.
Figure 6-10. Replacing the System Battery
8. Install the expansion card(s) in slot 1 and slot 2 (if applicable). See
9. Replace the cover. See "Replacing the
Cover" in "Troubleshooting Your System."
Bezel" in "Troubleshooting Your System."
Bezel" in "Troubleshooting Your System."
Cover" in "Troubleshooting Your System."
"Removing an Expansion
"Installing an Expansion
Cover" in "Troubleshooting Your System."
Card."
Card."