Responding To A Systems Management Software Alert Message; Removing The Bezel - Dell PowerEdge 700 Installation And Troubleshooting Manual

If the tests fail, continue to the next step.
2. Check the appropriate indicator on the NIC connector. See
If the link indicator does not light, check all cable connections.
l
If the activity indicator does not light, the network driver files might be damaged or missing.
l
Remove and reinstall the drivers if applicable. See the NIC's documentation.
Change the autonegotiation setting, if possible.
l
Use another connector on the switch or hub.
l
If you are using a NIC card instead of an integrated NIC, see the documentation for the NIC card.
3. Ensure that the appropriate drivers are installed and the protocols are bound. See the NIC's documentation.
4. Enter the System Setup program and confirm that the NIC is enabled. See "Using the System Setup Program" in your User's Guide.
5. Ensure that the NICs, hubs, and switches on the network are all set to the same data transmission speed. See the network equipment documentation.
6. Ensure that all network cables are of the proper type and do not exceed the maximum length. See "Network Cable Requirements" in your User's Guide.
Responding to a Systems Management Software Alert Message
Systems management software monitors critical system voltages and temperatures, fans, and hard drives in the system. Alert messages appear in the Alert
Log window. For information about the Alert Log window, see the systems management software documentation.
Bezel
The bezel has status and attention indicators.You must remove the bezel to remove the system cover.

Removing the Bezel

CAUTION: See your System Information Guide for complete information about safety precautions, working inside the computer, and protecting
against electrostatic discharge.
1. Using the system key, unlock the bezel. See Figure 5-1.
2. Slide the bezel latch toward the right side of the system.
3. Swing the top of the bezel away from the system, disengage the hooks at the bottom of the bezel, and lift the bezel away from the system.
Figure 5-1. Removing the Bezel
"NIC Indicator Codes" in "Indicators and Codes."