Dell PowerEdge 700 Installation And Troubleshooting Manual page 65

7. Pull the socket release lever upward to the fully open position. See Figure 6-8.
NOTICE: Be careful not to bend any of the pins when removing the processor. Bending the pins can permanently damage the processor.
8. Lift the processor out of the socket and leave the release lever in the open position so that the socket is ready for the new processor. See Figure 6-8.
Figure 6-8. Replacing the Processor
9. Unpack the new processor and heat sink.
If any of the pins on the processor appear bent, see
10. Ensure that the processor socket release lever is in the fully open position.
11. Align pin 1 on the processor (see Figure 6-8) with pin 1 on the processor socket.
NOTE: No force is needed to install the processor in the socket. When the processor is aligned correctly, it should drop into the socket.
12. Carefully install the processor in the socket and press it down lightly to seat it. See Figure 6-8.
"Getting Help" for instructions on obtaining technical assistance.