Dell PowerEdge 700 Installation And Troubleshooting Manual page 76

CAUTION: See your System Information Guide for complete information about safety precautions working inside the computer and protecting
against electrostatic discharge.
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Remove the bezel. See "Removing the
3. Lay the system on its right side.
4. Remove the cover. See "Removing the
5. Remove the cooling shroud. See
6. Disconnect the interface and power cables to the hard drives in the drive bay.
7. Remove the hard-drive bay. See
a. Loosen the four screws that secure the drive bay to the system.
b. Slide the hard-drive bay out of the system.
8. Remove the drive from the drive bay. See
a. Remove the screws that secure the drive in the hard-drive bay.
b. Slide the drive out of the drive bay.
Figure 7-5. Removing a SATA Hard Drive
Figure 7-6. Removing a Cabled SCSI Hard Drive
Bezel" in "Troubleshooting Your System."
Cover" in "Troubleshooting Your System."
"Removing the Cooling Shroud" in "Installing System Options."
Figure 7-5 and Figure 7-6.
Figure 7-5 and Figure 7-6.