Removing A Diskette Drive; Installing A Diskette Drive - Dell PowerEdge 700 Installation And Troubleshooting Manual

Systems
Hide thumbs Also See for PowerEdge 700:
Table of Contents

Advertisement

1.  Install the chassis drive insert by sliding the insert into the chassis until tabs on the side of the insert snap into place. See Figure 7-1.
2.  Install the bezel drive insert by sliding the insert into the bezel until the tabs on the side of the insert snap into place. See Figure 7-1.
3.  Install the bezel. See
"Installing the
4.  Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
 
Diskette Drive
 

Removing a Diskette Drive

 
CAUTION:
See your System Information Guide for complete information about safety precautions working inside the computer and protecting
against electrostatic discharge.
1.  Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2.  Remove the bezel. See
"Removing the
3.  Lay the system on its right side.
4.  Remove the cover. See
"Removing the
5.  Disconnect the power cable and the interface cable from the diskette drive. See Figure 7-2.
6.  Remove the two screws that secure the diskette drive in the externally accessible drive bay. See Figure 7-2.
7.  Slide the diskette drive forward out of the drive bay.
 

Installing a Diskette Drive

 
CAUTION:
See your System Information Guide for complete information about safety precautions working inside the computer and protecting
against electrostatic discharge.
1.  Unpack the drive and prepare the drive for installation.
 
For instructions, see the documentation that accompanied the drive.
2.  Slide the diskette drive into the externally accessible drive bay.
3.  Install the two screws that secure the diskette drive in the drive bay. See Figure 7-2.
4.  Connect the power cable and the interface cable to the diskette drive. See Figure 7-2.
5.  Install the cover. See
"Replacing the
6.  Stand the system upright.
7.  Install the bezel. See
"Installing the
8.  Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Figure 7-2. Removing a Diskette Drive
 
Bezel" in "Troubleshooting Your System."
Bezel" in "Troubleshooting Your System."
Cover" in "Troubleshooting Your System."
Cover" in "Troubleshooting Your System."
Bezel" in "Troubleshooting Your System."

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents